500-440 実際試験問題と解答 - 模擬練習 - 受験自信を増やす

Question No : 1
Which three system responses are valid if the Cisco Unified Contact Center Enterprise (centralized deployment with remote branches) and the remote branch lose the public network connection to both of the data centers? (Choose three.)

A.The local voice gateway detects the failure of the communications path. The voice gateway goes into SRST mode to provide local dial-tone functionality.
B.With Cisco Unified CVP, the voice gateway detects the loss of connection to the Cisco Unified CVP call server. The voice gateway then executes local bootstrap TCL script, answers the call, and forwards it to the hunt group.
C.The active call that arrived at the local PSTN connection and was answered by agent at that site remains active, however, the agent peripheral gateway loses access to the call and creates a TCD record.
D.The Cisco Finesse server detects the loss of connectivity to the agent desktop and automatically signs the agent out of the system.
E.With Cisco Unified CVP, the voice gateway detects the loss of connection to the Cisco Unified CVP call server. The voice gateway then connects to the communication manager cluster to provide local dial-tone functionality.

正解:

Question No : 2
Under which circumstances can the visible and private networks be converged in the Cisco Unified Contact Center Enterprise system?

A.when QoS is enabled on both networks
B.in cases in which there is gigabit bandwidth between sites
C.under no circumstances
D.when the Cisco Catalyst switch has dual power supplies

正解:

Question No : 3
Which three statements about QoS in a Cisco Unified Intelligent Contact Management solution are true? (Choose three.)

A.In a Cisco Unified Intelligent Contact Management network, if the traffic is marked in the ICM, QoS trust needs to be enabled on access-layer routers and switches.
B.The high priority queue for the private network should be granted 90 percent of total available bandwidth.
C.The high priority queue for the private network should be granted 75 percent of total available bandwidth.
D.The high priority queue for the private network should be granted 65 percent of total available bandwidth.
E.Traffic marking in Cisco Unified ICM means that configuring separate private high and private medium/ low sets of IP addresses is no longer necessary.
F.Traffic marking in Cisco Unified ICM means that configuring separate private high and private medium/ low sets of IP addresses is still necessary.

正解:

Question No : 4
Which two statements about the Cisco Unified Contact Center Enterprise clustering over the WAN deployment model are true? (Choose two.)

A.With Cisco Unified Computing System C-Series Servers, you must deploy dual SAN on each data center.
B.The visible network that supports the communication between Cisco Unified Communications Manager subscriber nodes must be highly available and designed with no single point of failure.
C.Agents at remote locations must be registered to only one data center for their Cisco Unified IP Phone connections if they are using Cisco Finesse.
D.Cisco Unified Contact Center Enterprise IVR Peripheral Gateway cannot be split between the data center locations to maintain a local JTAPI connection for call control.
E.Cisco Unified Communications Manager Peripheral Gateways that are split between the two data centers can share the same private network connection as the central controller (router and logger) components.

正解:

Question No : 5
Which failure scenario in the Cisco Unified Contact Center Enterprise solution stops all processing and routing of contact center calls?

A.ICM Call Router Side A fails at the same time that ICM Logger Side A fails.
B.ICM Call Router Side A fails at the same time that ICM Logger Side B fails.
C.ICM Call Router Side B fails at the same time that ICM Logger Side A fails.
D.ICM Call Router Side B fails at the same time that ICM Logger Side B fails.
E.ICM Call Router Side A fails at the same time that ICM Call Router Side B fails.
F.ICM Logger Side A fails at the same time that ICM Logger Side B fails.

正解:

Question No : 6
A Cisco Unified Contact Center Enterprise solution is designed with geographic redundancy for the central controllers (with separate call routers and loggers). If Call Router Side A has device majority and its Ethernet private network NIC fails, which two events occur? (Choose two.)

A.The Call Router Side B stays active, while the Call Router Side A goes idle.
B.The Call Router Side A stays active, while Call Router Side B goes idle.
C.There is no ability to make ICM configuration changes.
D.Both sides go out of service for small period of time, Call Router Side A goes active, and Call Router Side B goes idle.
E.The system operates as it did prior to failure.

正解:

Question No : 7
To maintain end-to-end reporting context, when an agent transfers a call to another ICM Skill Group, to which Cisco Unified Communications Manager configuration object should the call be transferred?

A.route pattern
B.agent IP phone
C.CTI route point
D.translation pattern
E.translation route

正解:

Question No : 8
Which option describes the recommended way to configure redundant Cisco Unified Communications Manager subscribers for Cisco IP phone registration in a single cluster for the Cisco Unified Contact Center Enterprise solution?

A.Add a redundant device pool to the Cisco Unified CallManager Group configuration.
B.Add a second TFTP server to the cluster.
C.Add an additional Cisco Unified Communications Manager subscriber to the Cisco Unified Communications Manager Group defined in device pool of the Cisco IP Phone.
D.Use an SRST reference in the device pool.

正解:

Question No : 9
In the Cisco Unified Contact Center Enterprise solution with clustering over the WAN, which statement about the Cisco Unified Communications Manager peripheral gateway duplex pair is true?

A.Each side of the peripheral gateway pair (side A and side B) must be configured to point to a local and a remote CTI Manager across the WAN from the PG location.
B.The peripheral gateway private network may be shared with any other private connections-- peripheral gateways or call routers/loggers.
C.The peripheral gateway may use the highly available WAN connection between the sites (visible network) for all traffic--visible and private.
D.The peripheral gateways must be co-located at one side or the other of the Cisco Unified Communications Manager cluster.

正解:

Question No : 10
Which two statements about combining IP telephony and Cisco Unified Contact Center Enterprise Extensions on the same IP phone are true? (Choose two.)

A.Cisco Unified CCE supports only one agent ACD line on the IP phone.
B.The ACD line on the IP phone may have voicemail or call forwarding defined.
C.In a typical call center, the ACD line is the first line on the phone to make it easier for the agent to forward inbound ACD calls.
D.The agent state changes based on the activity of the ACD line.
E.If the agent picks up the phone to place a call, the agent is put into ready mode.

正解:

Question No : 11
Refer to the exhibit.

In Cisco Finesse 10.0(x), when agents login into the desktop as a Mobile Agent, which number is used in the highlighted Extension field?

A.the local CTI port dialed number
B.the remote CTI port dialed number
C.agent PSTN number (accessible from CUCM/GW)
D.agent ID
E.agent reservation script dialed number

正解:

Question No : 12
Which type of MTP is supported with Cisco Unified Mobile Agent?

A.MTP Pass-Through
B.MTP No Pass-Through
C.MTP Pass-Around
D.MTP No Pass-Around

正解:

Question No : 13
For the Cisco Contact Center Enterprise Outbound option, which Cisco Unified Communications Manager feature can be used to disable ring back during transfer to agent for a scenario that involves SIP trunks?

A.replaces header script
B.normalization script
C.association script
D.transformation script

正解:

Question No : 14
When using microapps, which core components are required for calls that originate from Cisco Unified Communications Manager to Cisco Unified CVP using Comprehensive mode?

A.CUCM: CTI Route Port, SIP Trunk, ICM: CVP Type 2 VRU, CUBE, VXML Gateway
B.CUCM: CTI Route Point and SIP Trunk, ICM: CVP Type 2 VRU and Network VRU labels, VXML Gateway
C.CUCM: CTI Route Point and SIP Trunk, ICM: CVP Type 10 VRU and Network VRU labels, VXML Gateway
D.CUCM: CTI Route Port and SIP Trunk, ICM: CVP Type 10 VRU and Network VRU labels, VXML Gateway

正解:

Question No : 15
In a Cisco Finesse 10.0(x) deployment, which option is needed from the primary and secondary servers for certificate authority to generate a root, intermediate, and application certificate for Cisco Finesse?

A.fully qualified domain name of the servers
B.physical MAC address of the NIC card from the Cisco Finesse servers
C.Certificate Signing Request
D.IP address of server
E.system ID of the server

正解:

Cisco 500-440 問題練習