300-365 実際試験問題と解答 - 模擬練習 - 受験自信を増やす

Question No : 1
A wireless engineer wants to enable optimized roaming for their 5GHz wireless network with these settings: -72dBm RSSI value, 25% coverage exception level percentage, and a minimum of 50 packets received.
Which two commands achieve these settings? (Choose two.)

A.config advanced 802.11a coverage data fail-percentage 25
B.config advanced 802.11b optimized-roaming enable
C.config advanced 802.11b coverage data rssi-threshold -72
D.config advanced 802.11a optimized-roaming enable
E.config advanced 802.11a coverage data rssi-threshold -72

正解:

Question No : 2
What address do PIM routers listen to in order to automatically discover the best RP for each multicast group?

A.224.0.0.13
B.224.0.1.39
C.224.0.0.14
D.224.0.140

正解:

Question No : 3
A customer requires that the remote site be able to utilize local servers when the AP is in WAN-
down (standalone mode).
Which AP mode must be configured on the wireless controller?

A.SE-Connect
B.Monitor
C.Local
D.FlexConnect
E.Sniffer
F.Rogue Detector

正解:

Question No : 4
What are two functions of the RAP in a mesh network? (Choose two.)

A.It provides a wired connection for the wireless mesh APs.
B.It adds capacity and resilience to a mesh area.
C.it creates a centralized management location for the mesh network.
D.it reduces the hop count to the wireless network that is connected to the edge.
E.it routes traffic from the wireless mesh to the wired network.

正解:

Question No : 5
CORRECT TEXT
Scenario
One of your colleagues has setup a test network in the lab to simulate a new building atone of your regional offices. Your team is testing AP failover. Your colleague has requested you to configure the WLCs so that in the event of a loss of one of the WLCsthe other wings APs will fail over to the remaining WLC.
The APs on the East-WLC-2504A should fail over to the West-WLC2-2504A, and the APs on the West-WLC2-2504A should fail over to the East-WLC-2504

A.Set the priority of the APs so the backup controller recognizes the join request from the higher-priority AP and if necessary disassociates a lower-priority AP to provide access to an available port. Not all menus, tabs and features are supported. Topology

正解:

Question No : 6
A customer has implemented a N+1 high availability plan in a multistory building. All APs on odd numbered floors are set as primary to WLC-A and all APs on even numbered floors are set as primary to WLC-8.
Which two problems are likely to arise from this design? (Choose two)

A.inconsistent CleanAir data due to multiple WLCs
B.floor-to-floor bleed-through that causes intercontroller roaming delays
C.AVC inconsistency due to multiple mobility group members
D.legacy device compatibility with multiple WLC configuration that causes disconnects
E.unpredictable AP loading during a WLC failure

正解:

Question No : 7
You have set up FlexConnect APs. For which scenario is Fast Roaming supported, providing the WLAN is mapped to the same VLAN and the client is roaming to an AP on the same Cisco WLC?

A.central switching with PMK (OKC) between different FlexConnect groups
B.local switching with Cisco Centralized Key Management within the same FlexConnect group
C.central switching with Cisco Centralized Key Management between different FlexConnect groups
D.local switching with PMKID within the same FlexConnect group

正解:

Question No : 8
CMX Facebook WiFi can allow access to the network before authentication.
Which two of the following options are available? (Choose two)

A.Allow all the traffic before authentication and intercept HTTPs only.
B.Allow HTTP traffic only before authentication and block all the traffic.
C.Allow SNMP traffic only before authentication and block all the traffic.
D.Allow all the traffic before authentication and intercept HTTP only.
E.Allow HTTPs traffic only before authentication and block all other traffic.

正解:

Question No : 9
A customer recently implemented WLC wireless multicast. Clients and connecting at the highest mandatory wireless rate of 24 Mbps and are receiving multicast traffic, but WLC cpu utilization and wired side network load has increased substantially.
What three actions should the engineer take next to optimize the configuration? (Choose Three)

A.verify that Global Multicast mode has been enabled
B.verify that IGMP snooping is disabled on the wireless controller since the access points are handing IGMP messages from the clients.
C.make sure the highest mandatory rate is set to 54 Mbps so that the multicast traffic has sufficient bandwidth
D.verify Multicast Listener Discovery (MLD) v1 snooping has been enabled to keep track of and deliver IPv4 multicast flows
E.change the wireless controller from Multicast-Unicastmodeto Multicast-Multicast mode and assign a multicast address in the 239.
F.X/8 subnet
G.verify that the L3 interfaces are configured for pirn sparse-dense-mode on the VLAN servicing the wireless access points as well as the wireless controller’s management VLAN

正解:

Question No : 10
A wireless engineer at a convention center has been asked to provision an SSID that can accommodate 4,000 users during a conference.
Which interface group configuration should be used?

A.One interface with /20 mask
B.Two interfaces with /21 mask
C.Four interfaces with /22 mask
D.Eight interfaces with /23 mask

正解:

Question No : 11
A customer has "quiet" wireless clients that use static IP addresses.
Which two WLAN configurations are required for these wireless clients to connect properly? (Choose two.)

A.Disable DHCP address assignment required.
B.Enable passive client.
C.Disable allow AAA override.
D.Enable static IP tunneling.
E.Disable DHCP server override.

正解:

Question No : 12
A client reports that video is not streaming. The administrator determines the client is connecting at a data rate of 12 Mbps and is trying to stream to a valid multicast address on the network.
What three items should the administrator check next to troubleshoot the issue? (Choose three)

A.IGMP snooping is turned off because the client cannot request to join a group, only access points can.
B.Video-stream for the multicast video is configured in the controller.
C.WLAN has been set for a QoS value of Platinum.
D.WLAN has been configured to allow multicast-direct to work correctly and multicast-direct has been enabled globally.
E.WLAN has been set for a QoS value of Gold.
F.RTSP is used to stream the video due to wireless multicast not using acknowledgements.

正解:

Question No : 13
Scenario
There is a problem with the East-WLC-2504A. When configuration changes are made to the Employees-East-Wing AP Group that covers the East-Wing, none of the APs receive the updates. Referto the exhibits to determine where the problems are.

Note, not all menu items, text boxes, or radio buttons are active.

What needs to be changed in the configuration of the East-WLC-2504A controller to restore functionality to the Employees-East-Wing AP Group? (Choose four.)
A. Change the AP in the Employees-East-Wing AP Group.
B. Change the IP Address in the east-wing interface.
C. Change the VLAN Identifier in the east-wing interface.
D. D. Enable Dynamic AP Management in the east-wing interface.
E. Change the Port Number to 2 in the east-wing interface.
F. Add the Primary Controller and IP address to the 3700-East-Wing AP.
G. Change the SSID in the Employees-East-Wing AP Group.
H. Change the Interface/Interface Group In the Employees-East-Wing AP Group.

正解: D,F,G,H

Question No : 14
After implementing mDNS gateway, a school's network administrator notices that mDNS wireless printers are available over the whole network.
Which feature can the admin use to restrict the printer mDNS advertisements to the AP that the printer is joined to and adjacent APs?

A.mDNS-AP
B.SSO
C.LSS
D.Priority MAC

正解:

Question No : 15
Which two methods to discover a controller does a MAP attempt when it boots up? (Choose two.)

A.|f Ethernet and wireless are available, it attempts to discover only via Ethernet.
B.if Ethernet is disconnected, it attempts to connect wirelessly using AWP
C.if only wireless is available and it is configured as a MAP, it does not attempt to connect to a WL
D.If Ethernet and wireless are available, it uses Ethernet first. If it cannot connect via Ethernet, then it chooses wireless.
E.|f Ethernet is disconnected, it attempts to connect wirelessly using the configured DHCP option.

正解:

Cisco 300-365 WIDEPLOY 問題練習