Cisco 210-060 CICD 問題練習

Question No : 1
Which two actions take place for proper operation when using Advanced Networking on VCS (Choose two.)?

• A.Automatic routing must be enabled.
• B.Manual route must be added using x command route add.
• C.Network interface must reside in the same subnet.
• D.NAT reflection must be enabled on the firewall.
• E.Network interface must reside in separate subnet.

答えを確認する

正解:

Question No : 2
End user is on a cisco telepresence session with remote participant and can control the camera at the remote endpoint.
Which feature is underlying?

• A.FECC
• B.DTMF
• C.FEC
• D.PIP

答えを確認する

正解:

Question No : 3
How to enable existing remote jabber to register to cucm without VPN?

• A.Expressway with jabber guest
• B.Vcs with jabber guest
• C.Expressway with MRA
• D.Vcs with MRA

答えを確認する

正解:

Question No : 4
Which command to assign manualy IP to EX series using CLI?

• A.Xcommand set network IPV4 address:
• B.xconfiguration network address Ethernet0:
• C.Xconfiguration network IPV4 address NIC0:
• D.Xconfiguration network IPV4 address:

答えを確認する

正解:

Question No : 5
Which three items are required to provision core telephony service on the Cisco Unified Communications Manager Express router? (Choose three.)

• A.MAC address
• B.IP source address
• C.Dial peer
• D.Ephone
• E.Max-dn
• F.Max-ephone

答えを確認する

正解:

Question No : 6
Which protocol is used between two Cisco IP phones once Cisco Unified Communications Manager Express connects a call?

• A.323
• B.RTP
• C.SCCP
• D.SIP

答えを確認する

正解:

Question No : 7
A Cisco IP phone fails to register with the Cisco CallManager.
Which choice should be checked first to isolate the issue?

• A.Cisco Discovery Protocol is enabled on the switch.
• B.The phone generates dhcp request packets.
• C.The phone generates TFTP request packets.
• D.Delete and re-create the phone.

答えを確認する

正解:

Question No : 8
A voice engineer is moving an IP phone from one secure Cisco Unified Communications Manager cluster to another. The phones are not registering to the new cluster.
Which task resolves this issue?

• A.reset the phones
• B.restart the phones
• C.delete the CTL file from each phone manually
• D.use the Bulk Administration Tool to import the phones

答えを確認する

正解:

Question No : 9
An IP phone that is using PoE shows "unknown" in Cisco Unified Communications Manager.
What should the engineer do to restore the phone to service?

• A.restart the phone from Cisco Unified Communications Manager
• B.reset the phone from Cisco Unified Communications Manager
• C.enter **# locally on the IP phone
• D.check the network cable and switch port

答えを確認する

正解:

Question No : 10
An administrator has been deleting phones from Cisco Unified Communications Manager, but would like to reassign those directory numbers.
Which two configuration areas within Cisco Unified Communications Manager allow the administrator to perform this task? (Choose two.)

• A.directory number
• B.route plan report
• C.dial rules
• D.intercluster directory URI
• E.dial plan installer

答えを確認する

正解:

Question No : 11
A user registered to Cisco Unified Communications Manager wants their cell phone to ring simultaneously with the IP phone.
Which three configuration points must be configured to achieve this configuration? (Choose three.)

• A.Enable Mobile Voice Access.
• B.Create Remote Destination Profile.
• C.Create Remote Destination.
• D.Enable Single Number Reach.
• E.Create Application Dial Rule.
• F.Enable Call Forwarding.

答えを確認する

正解:

Question No : 12
An engineer is configuring a group of DNs and wants the external phone number mask to match the last four digits of the DN.
Which option should be used?

• A.123555xxxx
• B.123555XXXX
• C.123555****
• D.123555....

答えを確認する

正解:

Question No : 13
An engineer is adding a third-party video endpoint to Cisco Unified Communications Manager.
Which third-party device type should be used when adding the system?

• A.SCCP
• B.SIP
• C.MGCP
• D.323

答えを確認する

正解:

Question No : 14
A network engineer must set up an end-user account for a SIP device to use for authentication.
Which end-user information is used for SIP authentication?

• A.account ID
• B.password
• C.PIN
• D.digest credentials

答えを確認する

正解:

Question No : 15
Which three devices can be used to provide analog ports for connecting traditional phones and fax machines? (Choose three.)

• A.Foreign Exchange Office Voice interface
• B.Foreign Exchange Station Voice Interface Card
• C.Cisco High Density VoiceFax Network Module
• D.Cisco ATA190 Analog Telephone Adapter
• E.Cisco VG350 Analog Voice Gateway
• F.Cisco Unified Border Element

答えを確認する

正解: